Bogen Pro 4 Installation Manual download pdf (Page 11)

4. Installation

4.1 Unpacking & Inspection

Your ProHold DRDX unit was carefully checked and inspected at the factory.

Inspect the carton and unit for signs of damage as you unpack your unit. If

damage is found, notify the dealer from whom the unit was purchased. If you

received the unit through the mail, you must file a claim with the carrier.

4.2 Installation Precautions

Please observe the following Installation Precautions:

• Do Not install the unit in damp areas, or in areas where it is likely to

be exposed to moisture.

• Do Not install the unit in areas where the ambient temperature is

likely to go below 40°F or exceed 90°F.

• Make sure to use suitable fasteners when mounting the unit on hol-

low walls or other similar thin materials. Plastic screw anchors are

provided.

4.3 Connecting Power Supply

Connect the output plug from the power supply included with the unit to the

9V AC jack on the rear panel of the ProHold DRDX. Plug the power supply

into any convenient 110V AC outlet.

4.4 Connecting to the PSTN

Network

Connect the RJ11 jack, (phone line jack) located on the rear panel of the

ProHold DRDX, to any convenient analog station line using the standard tele-

phone line cable provided with the unit.

Helpful HINT: Record the number of the phone line you are connecting to

ProHold DRDX - you will need it later.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Bogen Pro 4 Installation Manual Page 11